Tormek Knife Jig (SVM-45)

Tormek Knife Jig (SVM-45)

Incl. VAT

SKU: CET SVM-45 Categories: , ,

Product Description

The Tormek original grinding jig SVM-45 is suitable for all kinds of knives; household knives, chef’s knives, handicraft knives and knives for hunting and fishing. It also works with carver’s draw knives. The jig rests freely on the Universal Support so you can follow the curve of the blade.

(For knives with long and thin blades, see SVM-140.)


A Durable Edge

Compared to grinding methods where you quickly pull the knife through a knife sharpener or sharpen it by using a honing stone, the Tormek knife jigs restore the blade to its original and optimal edge angle. So you do not just sharpen or hone at the very tip of the edge, as you do with honing stones or with a sharpening steel, which causes the edge angle to increase unintentionally. After a few sharpenings by hand, the edge sooner or later will need to be restored to the correct edge angle.

new-2


Kind to the steel

Since the edge is continuously cooled with water, there is no risk that the steel will become overheated and lose its hardness. You remove the minimum amount of steel so your valuable knives will last for a long time.


Superior sharpness

The jig rests on the Universal Support and gives you full control over the edge angle. The burr that develops during sharpening is easily removed on the Tormek Leather Honing Wheel where it is polished to a razor edge. You get a superior sharpness that will last longer.


Edge angles for different usage

You can set a suitable edge angle by using the Tormek AngleMaster that comes with the machine. A knife for cutting meat should have a larger edge angle then a knife for cutting vegetables. A small edge angle (25°) will cut easily but it will also be more sensitive to wear and damage. A larger edge angle (40°) will give a stronger and more durable edge.

edge_angles_knives_en_530


Design

The jig for knife sharpening comprises an adjustable clamp (1) for holding knives of any thickness and an adjustable stop (2). You adjust the jig to the knife thickness with the screw (3) and lock by tightening the knob (4).

The Universal Support is normally placed vertically for knife sharpening towards the edge. Short knives can also be ground away from the edge with the Universal Support placed horizontally.

Min. blade length 60 mm (2 3/8″).

svm45_design_170


Improvement to the Knife Jig

We now cast the Knife Jig SVM-45 in zinc, which give us the opportunity to make the clamping jaws thinner. The benefit is that they can handle smaller edge angles and narrower blades, where the earlier design would touch the stone.

Now you can sharpen blades min 14 mm (9/16″) measured from the back to the cutting edge. The dashed line shows the earlier design. (Knife 2.5 mm thick, width 14 mm.)

svm45_comparison_530


Downloads:

PDF Knife Jig SVM-45 Instruction.
PDF SVM-45 Parts breakdown

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Pre-Sale Questions

There are no questions yet.

Ask a question about “Tormek Knife Jig (SVM-45)”

Works well with

Suggest more products